Automatic bussing system


IC200AR aims to provide solutions for problems and restrictions of manual soldering, ensuring repeatability, accuracy and stability of results. The in-line system consists of a robotic workstation that prepares the measure, welds ribbon bussing strings to complete the electrical circuit before the module lamination.

The company states that attention has been paid for the choice and the integration of soldering technology and the vision system with the aim to ensure the combination of performance and reliability, reaching a cycle time of 80 seconds for each 72- cell module.

Popular content

This content is protected by copyright and may not be reused. If you want to cooperate with us and would like to reuse some of our content, please contact:


Related content

Elsewhere on pv magazine...

Leave a Reply

Please be mindful of our community standards.

Your email address will not be published. Required fields are marked *

By submitting this form you agree to pv magazine using your data for the purposes of publishing your comment.

Your personal data will only be disclosed or otherwise transmitted to third parties for the purposes of spam filtering or if this is necessary for technical maintenance of the website. Any other transfer to third parties will not take place unless this is justified on the basis of applicable data protection regulations or if pv magazine is legally obliged to do so.

You may revoke this consent at any time with effect for the future, in which case your personal data will be deleted immediately. Otherwise, your data will be deleted if pv magazine has processed your request or the purpose of data storage is fulfilled.

Further information on data privacy can be found in our Data Protection Policy.