Variable trapezoidal plate shoe


The usual trapezoidal sheet metal shoes have to be specially produced for each corrugation size. The new model is fastened with two self-drilling screws and can accept assembly profiles and complete systems. An EPDM (ethylene propylene diene monomer rubber) tape, already fastened to the shoe, seals the roof and the resulting holes.

The shoe can be used for trapezoidal sheet angled between 30 and 84 degrees. No matter what the width of the corrugations, this stainless steel plate component can be used for arrays mounted either parallel with the roof or on standoffs. The system can be supplied as a component or as an assembly kit. The kit consists of two fasteners with EPDM tape, four self-drilling screws, and a standard 450-millimeter rail by Altec Solartechnik.

Popular content

This content is protected by copyright and may not be reused. If you want to cooperate with us and would like to reuse some of our content, please contact:


Related content

Elsewhere on pv magazine...

Leave a Reply

Please be mindful of our community standards.

Your email address will not be published. Required fields are marked *

By submitting this form you agree to pv magazine using your data for the purposes of publishing your comment.

Your personal data will only be disclosed or otherwise transmitted to third parties for the purposes of spam filtering or if this is necessary for technical maintenance of the website. Any other transfer to third parties will not take place unless this is justified on the basis of applicable data protection regulations or if pv magazine is legally obliged to do so.

You may revoke this consent at any time with effect for the future, in which case your personal data will be deleted immediately. Otherwise, your data will be deleted if pv magazine has processed your request or the purpose of data storage is fulfilled.

Further information on data privacy can be found in our Data Protection Policy.