Skip to content

Modules & Upstream Manufacturing

Storing balcony solar power with lithium batteries for e-bikes

Scientists in Germany have assessed the performance of balcony solar modules connected to an e-bike battery and found this combination provides a stable and continuous operation over three days. They tested two system architectures based on passive and active hybridization and said both system designs offer satisfying results.

1

Insolation Energy plans 600 MW solar cell factory in India

Insolation Energy, an Indian solar module manufacturer, is setting up a 600 MW PV cell production facility. It is also expanding its panel production capacity from 700 MW to 1.2 GW.

Test shows higher yield, lower degradation for n-type solar modules

Research carried out by China‘s National Photovoltaic Quality Inspection Center shows that new n-type TOPCon modules are living up to their promise, outperforming the previous generation of p-type PERC products. Data gathered over six months from a fixed-tilt PV system showed that the n-type products produced 3.69% more energy, and also suffered much lower performance losses.

1

Maxeon’s PV module capacity hits 2.5 GW in Mexico

Maxeon Solar Technologies says it has invested $70 million to upgrade its panel factory in Mexicali, Mexico, to 1.8 GW. The remaining capacity is provided by a 700 MW facility that the Singapore-based manufacturer operates in Ensenada.

2

Australian startup launches 6 kW / 7.2 kWh mobile solar generator

Decarbon Venture has launched what it claims to be the world’s first “swappable” solar generator at half the weight and double the power rating of other products on the market.

2

Novel non-contact soldering technique for ribbon tabbing in solar cell manufacturing

Finnish scientists have tested a new eddy current-based soldering method for ribbon tabbing in solar cells and have found it considerably reduces the number of cracks and damages caused by thermal-mechanical stress in the process. They claim the new technique may already compete with conventional soldering methods in commercial production.

Impact of solar module soiling on grid-forming inverters

New research from Serbia claims air-polluted urban climatic conditions may not only induce maximum power point (MPP) tracking problems in PV systems but also reduce power yield by up to 30%. The scientists also said that soiling may significantly affect the functionality of single-stage inverters operating in grid-forming mode.

Solar passports to support PV waste management in India

A new study proposes blockchain-based solar passports to address the PV waste management challenge in India. It says such a framework would enable transparent tracking and verification of PV panels throughout their life cycle.

SEG Solar leases land for 5 GW cell, 3 GW module production in Indonesia

SEG Solar (SEG), a Texas-based module manufacturer, will lease land in Indonesia for 5 GW of solar cell and 3 GW of PV module capacity.

3

Offshore floating vs. land-based PV systems

A group of researchers from Utrecht University analyzed offshore floating photovoltaic (OFPV) systems to determine reasons for enhanced performance compared with land-based systems. Out of their research, the team developed two regression models to help predict yield advantages when siting projects.

1

This website uses cookies to anonymously count visitor numbers. View our privacy policy.

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close