A Tesla Megapack battery caught fire at PG&E’s Elkhorn large-scale battery storage facility in Monterey County, California, in the early hours of September 21. The fire was brought fully under control by the late afternoon, and its cause is under investigation.
Firefighters were able to extinguish a fire that broke out on Aug. 1 in the transformation center of the Ekian solar park in Álava, Spain.
The fire affected an area of around 5,000 square meters but did not damage the solar panels. The local fire brigade was able to control the fire in around two hours.
The Australian Competition and Consumer Commission has issued a call for homeowners to check their residential energy storage systems, amid a national recall of that batteries due to concerns about overheating.
Fire crews in Chandler, Arizona, sent robots into a building at the Salt River Project where a 10 MW battery was smoldering.
The German battery manufacturer said this week its residential storage systems were automatically switched to a regulated stand-by mode in Germany. The background to the remote shutdown is three reports of explosions in houses in which Senec products were installed.
A weekend fire caused by a lithium-ion home battery system in Adelaide, Australia, has prompted the authorities to urge solar and battery owners to be vigilant about system maintenance.
The Australian rooftop PV market is expected to eclipse all previous records in 2020, but a new report has raised serious questions about the fire safety standards associated with small-scale solar installations.
During an online launch event, a Blade Battery pack was pierced with a nail without becoming unstable or experiencing dangerous high temperatures. The company says the device will be safer during car accidents.
This website uses cookies to anonymously count visitor numbers. View our privacy policy.
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.