Adani Solar has unveiled an n-type TOPCon bifacial solar module featuring Indian-made cells this week at Intersolar India 2024. The module is available in power range from 550 W to 575 W, with an efficiency of 21.4% to 22.4%
The heat pump uses R-410a as a refrigerant and has a size ranging from 2 tons to 5 tons or 7.0 kW to 17.6 kW. It also has a cooling capacity spanning from 6.7 kW to 15.5 kW.
Developed by scientists in Germany, the triple-junction cell is based on a perovskite top cell with an energy bandgap of 1.84 eV, a perovskite middle cell with bandgap of 1.52 eV, and a silicon bottom cell with a bandgap of 1.1 eV. The device achieved an open-circuit voltage of 2.84 V, a short-circuit current of 11.6 mA cm–2, and a fill factor of 74%.
Trina Storage has developed a 4.07 MWh energy storage system featuring its in-house 306 Ah lithium iron phosphate battery cells, configured with 10 racks of four battery packs.
An energy makeover of a heritage-listed church built in 1965 included new solar PV roof, new insulation, new windows, and heat pumps, enabling it to produce 149% of its energy requirements. The achievement garnered the project team the Norman Foster Solar Award 2023.
Ahead of the upcoming introduction of EU Ecodesign and Energy Label policy measures for solar PV products, SolarPower Europe brings some reflections on the topic, adding insights to the ongoing industry discussions.
The Japanese electronics manufacturer said its new heat pumps are suitable for commercial, industrial, and multi-dwelling residential applications. The new products feature a rated power ranging from 50 kW to 80 kW and a coefficient of performance spanning from 3.2 to 3.4.
A Spanish-Italian research team has investigated different system configurations for bifacial agrivoltaic solar arrays deployed in olive groves and has found that the solar modules’ tilt angle has a significant impact on power yield while their height plays a crucial role on increasing agricultural yield.
A Japanese-German research team has fabricated a TOPCon PV device by replacing common ion implantation techniques with plasma immersion ion implantation (PIII). The resulting device showed almost the same efficiency as TOPCon cells produced with conventional Beam line ion implantation systems.
Netherlands-based Autarco has developed a new mounting structure for large PV modules in commercial and industrial arrays.
This website uses cookies to anonymously count visitor numbers. View our privacy policy.
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.